The history of the shower room is much shorter than that of the bathtub, but the shower room is more convenient and sanitary. Therefore, in the housing decoration, the shower room has become the choice of many citizens. How to install the shower room, the editor will teach you 6 tips:
1. Coat some glass glue on the cylinder of the mounting parts (the purpose of coating glass glue: one is to increase lubrication and facilitate installation; the other is that after the glass glue is solidified, the shower curtain rod will be more durable).
2. Drive the canopy wire with the mounting parts into the wall, and tighten the canopy wire.
3. Clean the wall and wipe off the excess glass glue. After 24 hours, it can be used normally.
4. Use a drill with a diameter of 12mm to drill a hole on the wall (the drilling depth is about 6cm). When drilling, let the drill bit go down a little bit, and the buttocks will go up a little bit after the electric drill, which can effectively prevent the shower curtain rod from sagging.
5. The shower curtain rod is generally installed at a height of about 2.06 meters from the ground (the specific situation can be determined according to personal habits and the height of the bathroom). Place the shower curtain rod at the position where you need to install it and compare it to determine the drilling position and make a mark.
6. Carefully perform the instructions and check whether the product spare parts are complete.